There are many ways to increase the energy efficiency of an existing system which also helps invariably to cut your carbon footprint. The inefficiencies breed pollution. Such inefficiencies can emanate from power generation methods or from power distribution methods. Energy cannot be stored but has to be used. That is one of the main reasons why the power companies look for large consumers and offer them the lowest tariff. Some industries like Caustic soda plants and Aluminum smelters, consume large power.
If you are using power from the grid then you can discuss with your service provider and check whether you can switch over to green power. The tariff may be slightly higher than a standard tariff but certainly helps you to reduce your carbon footprint. Some service providers show your carbon foot print by way a chart in their monthly energy bill. Most of the energy providers supply green power such as solar and wind as part of their energy mix to make sure that they don’t lose customers who may insist on green power.
You can check various power tariffs in your place such a peak tariff and off-peak tariffs and you will be surprised at the difference. The peak tariff is when everybody use power , normally 9am to 5pm.The usage of air-conditioners during peak hours in tropical countries is high They can use rooftop solar panels with batteries and inverters because many counties in Asia do not have feed-in tariff method by which you can export your surplus solar power to the grid. Moreover they do not have a choice in selecting a service provider because power generation and distribution are mostly runs by Governments or by very few service providers. The best method for such users is to store the solar energy in batteries and use them when they want. Even consumers who use grid power can store electricity during off-peak period using batteries and then use them during peak period using an inverter. This is an ideal solution for Asian countries where the power outage is frequent and unexpected.
The best method will be to use an Electrolyzer to generate Hydrogen using off-peak power and tape water and store them under pressure. You can generate your own electricity using small Fuel cell .This electricity can be a Direct current that can be readily connected to a host of Direct current operated appliances including your air-conditioners and refrigerators. If your electricity load is relatively high then you can integrate both solar panels and grid power in such a way that you can store enough electricity by way of Hydrogen or in a battery and use them during peak period. By this method you can be certain of an uninterrupted power supply and at the same time a reasonable power tariff. You can reduce your carbon foot print substantially by utilizing solar power with Hydrogen storage.
You can choose energy-efficient appliances by looking at their star ratings.A star rating of 6 and above is considered very energy-efficient. You can choose LED bulbs for lighting and I would suggest using Direct current for LED bulbs directly from Fuel cell or battery and not from grid supply using an inverter. You can also check the type of refrigerants used in air conditioners and Refrigerators and their star ratings. If you have a roof top solar panel as part of electricity supply then I will recommend to use Direct current operated Air-conditioners and regfigerators.When you choose these appliances you can look for the type of motor, compressor and fans used, because these are the main parts that use electricity. An energy-efficient motor and the type of compressor used are critical components in determining the capacity, airflow and noise levels. The energy ratings are based on these factors only.
You can save energy and cut your carbon footprint in every step of the way if you are keen to do it. The most important factor in achieving energy efficiency is an understanding of your contribution to the environment and the prudence with which you can achieve these goals.